Abicor Binzel ROBO Compact W600 Betriebsanleitung Seite 46

9 Maintenance and cleaning
9.3 Replacing wear parts
1
1 Gas nozzle
Fig. 7 Replacing wear parts
EN - 20
NOTICE
• Use only original ABICOR BINZEL wear parts.
• Use the ABICOR BINZEL switch key wrench to mount and disassemble
the wear parts, and make sure that the connections are properly
assigned.
• Use the average tightening torque to tighten the wear parts.
 Tab. 12 Tightening torques for wear parts on page EN-21
• Replace any damaged, deformed or worn parts.
• Spray the wear parts with ABICOR BINZEL anti-spatter fluid.
• Test the TCP in the alignment jig after every use or following a collision.
Replace wear parts in accordance with the figures below:
Disassembly A: (1), (2), (3), (4)
Mounting direction B: (4), (3), (2), (1)
2
2 Contact tip
3
3 Tip adaptor
ROBO Compact W600
4
4 Gas diffuser