Abicor Binzel ROBO Compact W600 Betriebsanleitung Seite 40

6 Putting into operation
6.3 Connecting the coolant
EN - 14
WARNING
Risk of burns
The ROBO welding torch cable assembly overheats if the coolant flow is
inadequate.
• Wear protective gloves.
• Check the coolant level at regular intervals.
NOTICE
• Check the minimum fill level on the cooling unit.
• Ensure that the coolant supply and return hoses have been correctly
installed. Coolant supply = blue, coolant return = red.
• Do not use deionised or demineralised water as coolant or for leak and
flow tests. This may shorten your welding torch's service life.
• For liquid-cooled welding torches, we recommend using
ABICOR BINZEL BTC coolant.
 Please consult the applicable safety data sheet.
• The cooling system must be purged of any air each time the device is
commissioned and after every cable assembly change: disconnect the
coolant return hose from the coolant recirculator and hold it over a
collection receptacle. Close the opening on the coolant return hose. Then
re-open it by abruptly releasing it. Repeat until the coolant flows into the
collection receptacle continuously and without air bubbles.
 6.1.1 Euro-ZA on page EN-12
 6.1.2 RPC on page EN-12
1 Connect the coolant supply hose (5) and the coolant return hose (6) to the
coolant recirculator.
ROBO Compact W600