Abicor Binzel ROBO Compact W600 Betriebsanleitung Seite 41

ROBO Compact W600
6.3.1 Connecting and adjusting the shielding gas volume
6.3.2 Connecting the control lead
torch-side
Emerg. stop 2
Emerg. stop 3
Emerg. stop 1
Button
Button
Current sensor
Gas nozzle sensor
* only connected in case of cable assemblies with emergency stop function
Fig. 6 Connecting the control lead
NOTICE
• The type and amount of shielding gas used depend on the welding task
and the gas nozzle geometry.
• Make all shielding gas connections gas-tight.
• To prevent the shielding gas supply from becoming clogged by
impurities, the cylinder valve must be opened briefly before connecting
the cylinder. This will expel any impurities that may be present.
1 Connect the shielding gas cylinder to the wire feeder system.
2 Use the pressure reducer on the shielding gas cylinder to set the gas volume.
3 Depending on the version (Euro-ZA Panasonic
shielding gas connector correctly.
Control lead 7-wire
100.0084
The control lead of the machine is open. The customer must connect a suitable
plug. If all data is provided, the system will be supplied ready for connection.
Otherwise, choose a compatible plug for your power source and connect it to
the corresponding leads according to the terminal diagram.
WH
BN
GN
YE
GY
BU
PK
6 Putting into operation
®
connector), mount the
machine-side
B*
C*
A*
n.c.
n.c.
n.c.
n.c.
EN - 15