Setup On An Uneven Surface; General View Of Application; Application; Coating Material - WAGNER SUPER FINISH 23 PRO Originalbetriebsanleitung

Super Finish 23 Pro
1.20

SETUP ON AN UNEVEN SURFACE

The front end must always point downwards in order to avoid
sliding away.
If possible do not use the unit on an inclined surface since the
unit tends to wander through the resulting vibrations.
SAFETY REGULATIONS/ GENERAL VIEW OF APPLICATION
2

GENERAL VIEW OF APPLICATION

2.1

APPLICATION

SF 23 Pro is an electric driven unit for the airless atomization of
different painting materials. Also it is able to feed the internal
feeded paint roller, which is available as accessory.
SF 23 Pro is made for jobs in the workshop and on the build-
ing site.
The SF 23 Pro's device output is designed so that dispersions
can be processed indoors and outdoors for small to medium-
sized objects.
When painting, the device is suitable for all kinds of typical
painting jobs, e.g.:
doors, door frames, balustrades, furniture, woodencladding,
fences, radiators (heating) and steel parts.
We recommend using the top container for paintwork.
2.2

COATING MATERIAL

Diluting lacquers and paints or those containing solvents, two-
component coating materials, dispersion and latex paints.
No other materials should be used for spraying without WAG-
NER's approval.
Pay attention to the Airless quality of the
coating materials to be processed.
The unit is able to process coating materials with up to
20,000 mPas. If highly viscous coating materials cannot be tak-
en in or the performance of the unit is to low, the paint must
be diluted in accordance with the manufacturer's instructions.
Attention: Make sure, when stirring up with
motor-driven agitators that no air bubbles
are stirred in. Air bubbles disturb when spray-
ing and can, in fact, lead to interruption of
operation.
2.2.1
COATING MATERIALS WITH SHARP-EDGED
ADDITIONAL MATERIALS
These particles have a strong wear and tear effect on valves
and tips, but also on the heating hose and spray gun. This im-
pairs the durability of these wearing parts considerably.
GB
39