Grass Catcher; Necessary Tools; Unpacking - EMAK EF 92 Betribs- Und Wartungsanleitung

3.3.1 STEERING WHEEL, SEAT AND BATTERY
a) Attach the seat:
Place the seat in its place on the machine and secure it using four bolts, pre-mounted
in the seat. Before tightening the bolts, set the desired position of the seat to match
your body size.
b) Connect the cable of the safety switch:
Connect the electric cable to the switch connector on the underside of the seat.
c) Install the steering wheel:
Seat the steering wheel on to the shaft (1) and turn it so that the holes in the steering
wheel and the shaft align.
Insert the supplied pin (2) into the hole and knock it in using a hammer.
d) Connect the battery:
Bolts and rubber battery caps are located in the bag with the documentation and
other joining material.
Turn the lever of the storage space cover located under the steering wheel to open the
cover and take it out.
Loosen the bolts on the pole terminals.
Red wire Place on the (+) pole of the battery and secure in place with the bolt.
Brown wire Place on the (-) pole of the battery and secure in place with the bolt.
Place the rubber caps on to both leads.
Put the storage space cover back and secure with the lever.
- Connecting the wires in opposite to that described above will damage the machine.
- When disconnecting the battery, always disconnect the negative (–) pole of the battery
first.
- When putting the battery into operation and when performing maintenance on it, proceed
according to the instructions in the user's manual for the battery. Also follow all safety
instructions contained therein.

3.3.2 GRASS CATCHER

The grass catcher is supplied packed in a separate box. For transportation reasons some of its parts are
demounted and they first need to be assembled. The following chapters provide a rough indication of
their assembly. A detailed procedure is provided on the CD included with the mower, or we can send it
to you on request.

NECESSARY TOOLS

For the assembly of the grass catcher, prepare the following tools:
A knife for removing
packaging materials

UNPACKING

Remove packaging materials. First take out the lid, frame and sack and then the wrapped individual
parts. Unpack these parts and arrange them clearly in a suitable place.
A set of socket wrenches with
hex heads and hex wrenches
32
Philips screwdrivers
or a handheld electric
screwdriver
3.3.1a
3.3.1b
3.3.1c
3.3.1d