Getting Started (Including Display Modes); Fitting The Batteries - Elcometer 307 Gebrauchsanleitung

4 GETTING STARTED

4.1 FITTING THE BATTERIES

Each gauge is supplied with 2 x AA alkaline
batteries.
To insert or replace the batteries:
1 Lift the latch on the battery compartment
cover and rotate anti-clockwise to remove
the cover.
2 Insert 2 batteries taking care to ensure
correct polarity.
3 Refit the cover and rotate the latch clockwise to close.
The battery condition is indicated by a symbol in the top right of the
display ( ):
Full symbol (orange) = batteries at full capacity

Empty symbol (red, flashing) = batteries at lowest

sustainable level
4.2 CONNECTING A TRANSDUCER
1 Align the red dot on the transducer
plug with the red dot on the base
of the gauge.
2 Push the transducer into the
gauge, ensuring that the connector
is fully engaged.
All single element delay line
transducers which can be connected
directly to the base of the gauge -
see Section 15.1 'Transducers' on
page en-25 - are 'intelligent' transducers.
The transducer frequency and diameter will be identified automatically
by the gauge and the user will be prompted to select the type of delay
line attached (if any).
Details of the transducer connected can be viewed at any time via
Menu/About/Transducer Information.
www.elcometer.com
R
+
+
en-4