Technical Data - Zanussi THE8050 Benutzerinformation

Problem
The appliance stops during operation.
The display shows a long programme duration.
The display shows a short programme duration.
The display shows Err.
The display shows (e.g. E51).
1) After maximum 5 hours, the programme ends automatically
If the drying results are not satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the appliance.

TECHNICAL DATA

Height x Width x Depth
Max. depth with the appliance door open
Max. width with the appliance door open
Adjustable height
Drum volume
Maximum load volume
Voltage
Frequency
62
Possible solution
Make sure that the laundry does not catch be-
tween the appliance door and the rubber seal.
Make sure that the water container is empty.
Press Départ/Pause (Start/Pause) to start the
programme again.
Make sure that the weight of the laundry is appli-
1)
cable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Make sure that the room temperature is not too
warm.
Set the Minuterie (Time Drying) or the Extra Sec
(Extra Dry) programme.
If you want to set a new programme, deactivate
and activate the appliance.
Make sure that the options are applicable to the
programme.
Deactivate and activate the appliance. Start a
new programme. If the problem occurs again,
contact the Service.
• The drum is dirty.
• Incorrect setting of the conductivity sensor.
• The airflow slots are clogged.
850 x 600 x 600 mm (maximal 680 mm)
1090 mm
950 mm
850 mm (+ 15 mm - feet regulation)
118 l
8 kg
230 V
50 Hz