Herunterladen Inhalt Inhalt Diese Seite drucken

Technical Data - Zanussi ZTH485 Benutzerinformation

Vorschau ausblenden Andere Handbücher für ZTH485:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Fluff filters clogged.
Heat exchanger clogged.
Max. loading exceeded.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Loading door
Filters not locked in place.
does not close
Err ( Error ) on
Attempt to change parameters after start of the
5)
programme.
the LCD.
Programme selector in OFF position.
No drum light
Defective light bulb.
Abnormally
Time to end is calculated on the basis of: type,
elapsing time
volume and dampness of laundry.
5)
on the LCD
Programme in-
Full water reservoir.
active
Drying cycle to
Small laundry volume./Too dry laundry for se-
short
lected programme.
Fluff filters clogged.
To high loading volume.
Drying cycle to
Laundry insufficiently spun.
6)
long
Particularly high room temperature - no ma-
chine fault.
1) In case of error message on the LCD (e.g.
START PAUSE button. Does not work? - inform local service and quote the error code.
2) follow program recommendation - see
Care and cleaning chapter
3) see
Machine settings chapter
4) see
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see

Technical data

height x width x depth
drum volume
depth with the load door opened
All manuals and user guides at all-guides.com
E51 - only dryers with the LCD): Switch the dryer off and on. Set programme. Press the
Programme overview chapter
Drying cycle complete section).
85 x 60 x 58 cm
108 l
109 cm
3)
Clean fluff filters.
3)
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
4)
Set suitable water hardness
Install fine filter and/or snap course filter into
place.
Turn the dryer off and on. Set requested param-
eters.
Turn it to DRUM LIGHT (if available) or to any
programme.
Replace light bulb (see next section).
Automatic process; this is not a machine fault.
3)
Empty water reservoir
, press START PAUSE
button.
Select time programme or higher drying level
(e.g. EXTRA DRY ).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
Lower the room temperature if possible.
.
25

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis