Technical Data - Zanussi ZDH7332PZ Benutzerinformation

The appliance door does not close.
The appliance stops during operation.
Drying cycle lasts an unusually long time.
Drying cycle ends shortly after programme starts.
1) After maximum 5 hours, the programme ends automatically
If the drying results are not satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the appliance.

TECHNICAL DATA

Height x Width x Depth
Max. depth with the appliance door open
Max. width with the appliance door open
Adjustable height
Drum volume
Maximum load volume
Voltage
Frequency
Necessary fuse
Total power
Energy efficiency class
Energy consumption
Annual energy consumption
Problem
1)
2)
Make sure that the installation of the filter is cor-
rect.
Make sure that the laundry does not catch be-
tween the appliance door and the rubber seal.
Make sure that the water container is empty.
Press Start/Pause to start the programme again.
Make sure that the weight of the laundry is appli-
1)
cable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Make sure that the room temperature is not too
warm.
Set the Time Drying or the Extra Dry programme.
• The drum is dirty.
• Incorrect setting of the conductivity sensor.
• The airflow slots are clogged.
850 x 600 x 600 mm (maximal 680 mm)
1090 mm
950 mm
850 mm (+ 15 mm - feet regulation)
118 l
7 kg
230 V
50 Hz
5 A
950 W
A+
2,17 kWh
260 kWh
Possible solution
27