Care And Cleaning - Kenwood TOG800 Bedienungsanleitungen

To stop toasting during the cycle,
l
press the 'cancel' button, the toast
will pop up and the 'cancel' button
light will go off.
5 Your toast will pop up
automatically, to raise it higher,
lift the lever.
Defrost position
To defrost frozen bread, select the
l
defrost position on the browning
control.
Reheat
To warm toast that has popped
l
up but gone cold, lower the toast
then press the 'reheat' button.
The'reheat' button will illuminate.
Bagel (A)
To toast bagels the cut face should
l
be facing the front of the toaster.
Select the desired browning setting
and lower the carriage lever.
Press the 'Bagel' button and it will
illuminate.
Note: when toasting using the
l
bagel button, the front element
will toast with a higher heat than
the element at the back of the
toaster. This will result in only
one side of the item being
toasted.
hints on using your
toaster
Select a lower setting for light
l
browning or for dry bread.
When toasting a single slice of
l
bread, you may notice a variation
in toast colour from one side to the
other - this is normal.
Dry/stale bread toasts more
l
quickly than fresh bread and thinly
sliced bread toasts more quickly
than thickly sliced bread. Therefore
the browning control should be set
at a lower setting than usual.
For best results ensure that
l
the bread slices are of an even
thickness, freshness and size.
In order to achieve uniform
l
browning we recommend you
wait a minimum of 30 seconds
between each toasting so that the
control can automatically reset.
Alternatively select a lower setting
when additional toasting is carried
out.

care and cleaning

1 Before cleaning, unplug your
toaster and let it cool down.
2 Wipe the outside of the toaster
with a damp cloth, then dry. Do
not use abrasives.
crumb tray
Slide out the crumb tray 3. Clean,
l
then replace. Do this regularly:
crumbs can smoke or even burn.
Do not dishwash the crumb
l
tray.
glass panel
Remove the glass panel for
l
cleaning by opening forward 4
and lift off 5. Wipe with a damp
cloth and dry.
Replace the panel by aligning the
l
slots 6 on the side of the panel
with the hinge pins 7 and close.
Note: the toaster will not
operate if the glass panel
is not fitted and locked
correctly.
Do not dishwash or immerse the
l
glass panel in water.
heating tubes
Do not touch or wipe the heating
l
tubes as this will damage them.
Any loose crumbs found under the
l
heating tube should be cleared by
remove the glass panel and gently
shaking the toaster to allow them
to drop into the crumb tray.
5