Configuration Using The Micropulse Configuration Tool (Only For Btl7-S510(B); Micropulse Configuration Tool; Connecting The Usb Communication Box; Configuration Options - Balluff BTL7-S5 serie Betriebsanleitung

BTL7-S5 _ _ (B)-M _ _ _ _ -A/B/CD/Y/Z(8)-NEX-S32/KA _ _
Micropulse Transducer - Rod Style
7

Configuration using the Micropulse Configuration Tool (only for BTL7-S510(B)-...)

7.1

Micropulse Configuration Tool

The BTL7-S510(B)-... transducer can be configured
quickly and simply on a PC using the Micropulse
Configuration Tool PC software.
The most important features include:
– Online display of the current position of the magnet
– Graphical support for setting the functions and curves
– Display of information on the connected transducer
– Selectable number formats and units for display
– Resetting to factory settings is possible
– Demo mode without having transducer connected
The PC software and associated manual can
be found in the Internet under
www.balluff.com.
7.2

Connecting the USB communication box

For BTL7-S510(B)-... transducers with connector, the
communication box must be looped in between the
transducer and controller. The communication box is
connected to the PC via a USB cable.
USB cable
Connection cable approx. 0.3 m
with connector (socket)
Fig. 7-1: Connecting the communication box with a connector
For a BTL7-S510(B)-...-KA_ _ transducer, the
communication lines La, Lb and GND must be connected
to the USB communication box.
USB cable
Fig. 7-2: Connecting the communication box with a cable
connection
When reading or writing data via the
Configuration Tool, the LED 2 flashes green.
18 english
Connection cable
approx. 0.3 m with
connector (plug)
Controller
8-pin 6-pin
Controller
8-pin
Connection cable
approx. 0.6 m with
luster terminal
7.3

Configuration options

Prerequisites
– USB communication box connected to the transducer
and PC.
– Software correctly installed.
– Transducer connected to the power supply.
– Magnet on transducer.
Output functions
Position: Position in the measuring range.
–
Speed: Speed of the magnet; the sign indicates the
–
direction of movement. A movement from the starting
point to end point is output with a positive sign; a
movement from the end point to the starting point is
output with a negative sign.
– Speed (unsigned): Speed of the magnet, the direction
of movement cannot be read.
– Differential position: Distance between two magnets.
Selection is only possible if two magnets have been
selected.
– Speed difference: The speeds of two magnets are
subtracted to form a sum. Selection is only possible if
two magnets have been selected.
Freely configurable curve
– The gradient of the characteristic curve can be set by
adjusting the resolution.
– The limits can be adjusted to the measuring range.
– The error value can be set.
Boundary conditions for several magnets
– Two magnets can only be selected from a nominal
length ≥ 90 mm.
– The distance between two magnets must be ≥ 65 mm.
DANGER
Uncontrolled system movement
When starting up, if the position measuring system is
part of a closed loop system whose parameters have not
yet been set, the system may perform uncontrolled
movements. This could result in personal injury and
equipment damage.
► The system must be taken out of operation before
configuration.
► Transducers may only be connected to the
communication box for configuration.
► The communication box must be removed after
configuration.
Ignition protection
"nA" and "tb"