Satelec Implant Center 2 Bedienungsanleitung Seite 41

b) Control unit back panel
The power receptacle (Fig. 2-1) with its grounding pin is used to connect the I
power supply using a plug-in power cord.
The footswitch connector (Fig. 2-2) is used to connect the I
footswitch.
The fan (Fig. 2-3) protected by a metal grille, keeps the I
level.
The bracket holders (Fig. 2-4) are used to install the brackets.
The power switch (Fig. 2-5) is used to switch the device ON or OFF.
c) Control unit sides
The pump housings (Fig. 1-8) are designed to accommodate SATELEC irrigation line cassettes.
The irrigation cassettes are installed by lifting the pump covers and inserting the cassettes horizontally
into the cassette housings.
d) Front panel
- The left connector is designed to accept the connector of the I-S
SATELEC micro-motor cord must be used.
- The right-hand connector is designed to accept the connector of the N
the connector of the P
e) Control footswitch
Having access to a large number of functions on the control footswitch allows the practitioner to work
in a perfectly sterile environment, avoiding the risk of cross-contamination.
Once the various settings have been adjusted, the user has no further need to touch the keypad.
Depending on the mode, the control footswitch buttons have different functions.
I-S mode:
URGE
Footswitch button definitions (Fig. 11-1 to 5)
- 1: -I-S motor control (ON/OFF or progressive).
URGE
- 2: Rotation direction.
- 3: Change program (P1 to P4).
- 4: Irrigation ON/OFF.
- 5: Select active handpiece.
P mode:
IEZOTOME
Footswitch button definition (Fig. 11-1 to 5).
- 1: Ultrasonics control (ON/OFF or progressive).
- 2: Flush/prime.
- 3: Change program (D1 to D4).
- 4: Irrigation ON/OFF.
- 5: Select active handpiece.
2 / P
IEZOTOME IEZOTOME
MPLANT
MPLANT
2 LED handpiece cord.
C
MPLANT
C 2 to the multifunction control
ENTER
C 2 at its optimal performance
ENTER
micro-motor cord. Only a
URGE
/ N
EWTRON EWTRON
2 to the
ENTER
LED cord or