Restoring Factory Defaults; Recall Data - Chauvin Arnoux DTR 8510 Bedienungsanleitung

NOTE: The language can also be selected immediately at start up. Press and hold the TEST button while turning the unit
ON. After initialization, the instrument will display the currently active language. Release the TEST button. The desired
language can now be selected.

4.3.9. RESTORING FACTORY DEFAULTS

The factory default settings are shown in the following table:
To set the instrument back to the factory default configuration:
1. Turn the DTR 8510 OFF.
®
2. Press and hold the  button.
3. Turn the DTR 8510 ON.
®
4. Release the  button when the instrument beeps.
NOTE: The previously stored Measurement Records will remain in the memory and the language will remain the same as
before the default configuration was loaded.

4.4. RECALL DATA

From the Main Screen, press the  or  key until Recall Data appears on the display, then press ENTER.
1.
The Measurement Record in OBJECT #01 and TEST #01 will be displayed, as well as the Ratio.
NOTE: The V after the Ratio indicates the VT/PT test type. C would be displayed if the Ratio was from a CT test.
text text.
Parameter
Test Mode
Test Type
Filter
Storage Mode
Language
Nameplate
Nameplate Values
Table 4-1
Figure 4-20
Default Value
Ratio
VT/PT
Normal
Manual
English
Disable
19920:7200
19920:4800
19920:2400
19920:2160
19920:120
7200:2400
7200:2160
7200:120
2400:120
2160:120
57
Text text