Scanning With Job Separation - Xerox DocuMate 3125 Benutzerhandbuch

® ®
Xerox DocuMate 3125
6. Select the scan configuration you want to use for scanning in the Select configuration list.
Click on the Edit button to open the Scan Configuration Properties window to configure
any destination specific scanning options.
Each destination that has per-scan configuration properties will be represented by its
configuration tab in the One Touch Scan Configuration Properties window. Please refer to
the destination instructions, as described in the previous section(s), for configuring
destination specific options.
Click on OK when you are done making changes in this window.
Click on OK on the One Touch Properties window.
7.
8. Load the document(s) in the scanner and start scanning with the button you set to scan to
multiple destinations.
The scanner starts scanning and when finished, the image is sent to each destination you
selected in the One Touch Properties window.
Technical Note
• The Still Image Client destination cannot be used with multiple destination scanning. This
destination will be disabled when the Enable scanning to multiple destinations is
selected.

Scanning with Job Separation

Use job separation to have One Touch create a new file each time a separator is detected when
scanning a multiple page batch. For example, if you want to scan financial statements from
several different banks, you can place a stack of statements in the scanner and One Touch will
separate each statement into a different file based on your selected job separator.
1. Open the One Touch Properties window.
6-85
Scanning and Configuring One Touch
User's Guide