Herunterladen Inhalt Inhalt Diese Seite drucken

Setup 5: Adjusting The Tilt - Sony SDM-S53 Bedienungsanleitung

Tft lcd color computer display
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 69
3
Turn on the computer.
The installation of your monitor is complete. If necessary, use the
monitor's controls to adjust the picture (page 10).
If no picture appears on your screen
• Check that the power cord and the video signal cable are
properly connected.
• If "NO INPUT SIGNAL" appears on the screen:
The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
• If "CABLE DISCONNECTED" appears on the screen:
Check that the video signal cable is properly connected.
• If "OUT OF RANGE" appears on the screen:
Reconnect the old monitor. Then adjust the computer's
graphics board within the following ranges.
SDM-S53
Horizontal
28–61 kHz
frequency
Vertical
48–75 Hz
frequency
1024 × 768 or less
Resolution
For more information about the on-screen messages, see "Trouble
symptoms and remedies" on page 18.
No need for specific drivers
The monitor complies with the "DDC" Plug & Play standard and
automatically detects all the monitor's information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.
The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.
SDM-S73/S93
28–80 kHz
48–75 Hz
1280 × 1024 or less

Setup 5: Adjusting the tilt

This display can be adjusted within the angles shown below.
Grasp the sides of the LCD panel, then adjust screen
angles.
SDM-S93 only
approx.
175°
approx. 175°
To use the monitor comfortably
Adjust the viewing angle of your monitor according to the height
of your desk and chair, and so that light is not reflected from the
screen to your eyes.
Note
When adjusting the screen tilt and height, proceed slowly and carefully,
being sure not to hit the monitor against the desk.
approx.
approx.
30°
GB
ME NU
OK
ECO
9

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Sdm-s93Sdm-s73

Inhaltsverzeichnis