Philips RQ1296 Bedienungsanleitung Seite 127

Problem
The shaver does not
shave as well as it
used to.
The shaver does not
work when I press
the on/off button.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Centre in your country.
Possible cause
The shaving heads are damaged or worn.
Long hairs obstruct the shaving heads.
Specific types only: The Jet Clean System has
not cleaned the shaver properly, because
the cleaning fluid in the cleaning chamber is
soiled or the cleaning fluid level is too low.
The rechargeable battery is empty.
Specific types only: The travel lock
is activated.
The shaving unit is soiled or damaged to
such an extent that the motor cannot run.
In this case, the shaving unit symbol, the tap
symbol and the exclamation mark flash.
The temperature of the shaver is too high. In
this case, the shaver does not work and the
exclamation mark on the display flashes.
ENGLISH
Solution
Replace the shaving unit (see
chapter 'Replacement').
Clean the shaving heads by
following the steps of the
extra-thorough cleaning method
(see chapter 'Cleaning and
maintenance').
Clean the shaver thoroughly
before you continue shaving. If
necessary, clean and refill the
cleaning chamber (see chapter
'Cleaning and maintenance').
Recharge the battery (see
chapter 'Charging').
Press the on/off button for 3
seconds to deactivate the travel
lock.
Clean the shaving unit or replace
it (see chapters 'Cleaning and
maintenance' and 'Replacement').
Switch off the shaver and let
it cool down. As soon as the
temperature of the shaver has
dropped sufficiently, you can
switch on the shaver again.
25 25