BURG WÄCHTER TSE PRIME SET 5013 E-KEY Montage- Und Bedienungsanleitung Seite 31

TSE E-KEY user inst ruct ions
The E-KEY is intended as radio transmitter for releasing the cylinder. The
E-KEY can be subsequently programmed by means of a keypad or of a
TSEsoftware. The radio range of the E-KEY is up to 3 m. The principle of
its function is similar to that of a car locking system. The cylinder can be
controlled when the button is pressed once.
Funct ions of E-KEY
Door opening:
– Press 1 xbrie ¡ y, green LED ¡ ashes
– Automatic function (only together with a keypad) Hold the button
pressed for 6 seconds, green LED ¡ ashes brie ¡ y 2 x in a row
– Permanent mode (only together with optional software) Press the button
2 x, the green LED ¡ ashes always 2 xin a row per pressed button
In the automatic mode the door can be opened by pressing the
on the keypad. For this purpose, the E-KEY must be within the radio range.
This function will be deactivated automatically after a period of 15 minutes.
In the permanent mode, the door is unlocked for a period deœ ned in the
software without the need for entry of a code. When entering an opening
code during this period, the permanent release will be deactivated.
Programming mode:
The programming mode has three purposes:
– Registration of an E-KEY by means of a keypad or of the TSEsoftware
– Synchronization of the radio signal set up in the E-KEY with the
channel set in the lock
– Searching for the E-KEY within the TSEsoftware
Programming E-KEY
When programming the E KEY for the œ rst time, please press the button
once (green LED ¡ ashes) when being required to do so by the keypad or
by the software. When programming the E-KEY later on, please keep the
button pressed for a period of 10 seconds, until the green LED ¡ ashes three
times in a row. Then release the button.
Remarks:
In case the door opens with a delay of 3 to 7 seconds after the button on
the E KEY is pressed once, and the red LED ¡ ashes, the battery (CR2032)
in the E-KEY should be replaced immediately. In case the door opens with
a delay of 3 to 7 seconds after the button on the E-KEY is pressed once,
and the red LED does not ¡ ash, the batteries (2x 1.5V LR06 alkaline) in the
cylinder should be replaced. This applies also to the keypad, if installed.
E TSE PRIM E
button
English | 33