Putting The Machine Into Service; Before Starting The Engine; End Of Work - Grillo PRINCESS 9 Gebrauchs- Und Wartungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

INSTRUCTIONS FOR USE

PUTTING THE MACHINE INTO SERVICE:

1) make sure the machine is complete and that has not been damaged in transit.

6) Fill engine oil to level (refer to relevant engine handbook).

– Fill the tank with fuel.

STARTING THE ENGINE

– Open the fuel tap.

– Bring the throttle lever half way of its journey. If the engine is cold, turn the starter lever to CHOKE.

– Start the engine by pulling the pull-start handle hard.

– Once the engine is running, return the starter lever to RUN and the throttle lever almost to the mini-

mum setting.

CAUTION:

BEFORE ANY OPERATIONS ON THE ENGINE, REFER TO THE SPECIFIC HANDBOOK.

STARTING WORK

– Adjust the height position of the handlebar to obtain the optimum working position, using the relative

–

In the MR, 2 MR, PRO 2 MR models pull the RM lever to engage reverse gear. (Safety device: if it is

released even accidentally, the machine stops).

engine manual.

SERVICING

The cultivator is constructed to require very little servicing, but the following instructions should be fol-

lowed to keep it in perfect working order:

– Follow all the instructions in the engine handbook. It is essential to check the oil level every 4

working hours and change it about every 50 hours. Refer to the enclosed engine handbook for the

oil type.

screws.

– Oil the throttle and clutch cables.

Inhaltsverzeichnis