Maintenance; Optional Accessories - Makita PJ7000 Bedienungsanleitung

Edge-To-Edge Joint or at 45° for Miter Joint.
Follow steps 1 - 11 excluding steps 5 and 10
•
described above.
For T-Butt Joint only
Fit the two workpieces together as they will appear
•
in the finished joint position.
Lay the vertical workpiece on the horizontal one.
•
Clamp both workpieces to the workbench.
Remove the angle guide from the tool.
•
Follow the steps 2, 4, 6, 7, 8 and 11 described
•
above.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Fig.25
The tool and its air vents have to be kept clean. Regularly
clean the tool's air vents or whenever the vents start to
become obstructed.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Angle guide
•
Dust bag
•
Set plate 4
•
Lock nut wrench 20
•
Plate joiner blades
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
or attachments
Only use accessory or
are
8