Vectron Pos Mobilepro Iii Shutting Down; Hardware Reset - Vectron POS MobilePRO III Sicherheits- Und Installationsleitfaden

V E C T RON P O S MObIl EP RO III
4 .1 . 2 . Ve c tro n P OS M o b i l e P ro I I I S h u t ti n g d ow n
• Press simultaneously the on-/off key
• Release both keys.
The message "The system will shut down" is displayed.
As soon as the status-LEDs go out the
Vectron POS MobilePro III is switched off.
4 .1 . 3 . H a rd wa re res e t
In order to switch off the POS system independent of the POS
software you can carry out a hardware reset.
• Press simultaneously the on-/off key
• Keep both keys pressed even after the vibration alarm.
As soon as the status-LEDs go out the
Vectron POS MobilePro III is switched off.
34
on the keyboard and the soft key
keyboard until the status-LEDs blink blue and green and the
vibration motor is released briefly.
a
Data loss through hardware reset
Since the system is not shut down properly
with a hardware reset, this can cause data
loss.
X
on the keyboard and the soft key
keyboard.
NOTICE
Only use the hardware reset when the
system cannot be shut down.
at the bottom left
on top right on the
at the bottom left
on top right on the