B-3. Usb Interface Model - Star TSP700 serie Bedienungsanleitung

B-3. USB Interface Model

ON
OFF
No. 1 2 3 4 5 6 7 8
DIP-SW1
Switch
1-1 Command emulation (Ster Line mode)
1-2 Should not be changed (Should be set to on)
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment
1-5 USB mode (See below) *1
1-6 USB mode (See below) *1
1-7 Automatic status back function *2
1-8 Should not be changed (Should be set to on)
*1 USB Mode settings are enabled only when the firmware of the USB interface board is USB 2.00 or
later.
*2 Automatic status back function is disabled when USB mode is 0.
The factory settings of DIP switch are all on.
Switch 1-5
ON
OFF
ON
OFF
Note:
1) A STAR USB Printer Driver Set is needed for using the USB interface on
Windows 98 or 98SE. You can download the STAR USB Printer Driver
Set from the following website.
2) Download the Mode 2 (vendor class) driver set from the following website
for use.
Printer Driver URL http://www.star-m.jp/eng/dl/dl02.htm
Switch
2-1~2-4
The factory settings of DIP switch are all on.
DIP-SW1
Function
Switch 1-6
ON
ON
OFF
OFF
DIP-SW 2
Function
Always ON
ON
OFF
No. 1 2 3 4
DIP-SW2
ON
Always ON
Invalid
Invalid
USB Mode
Mode 0 (Printer class old)
Mode 2 (Vendor class)
Mode 1 (Printer class new)
(Reserved)
ON
Should be set to on
– 98 –
OFF
Valid
Valid
OFF