Fuse - TOHATSU BFT 60A Benutzerhandbuch

MAINTENANCE

Fuse

BLOWN FUSE
If the fuse blows, running the engine
will not charge the battery. Before
replacing the fuse, check the current
ratings of the electrical accessories
and ensure that there are no
abnormalities.
• Never use a fuse with a different
rating from that specified.
Serious damage to the electrical
system or a fire may result.
• Disconnect the battery cable at
the battery negative (–) terminal
before replacing the fuse.
Failure to do so may cause a
short circuit.
126
SPARE FUSES
(10 A, 15 A, 30 A)
ACG FUSE CASE LID
FUSE CASE LID
Fuse Rating
No.
40 A Alternator (regulator rectifier-battery charging)
(1) 10 A Fuel pump (high pressure side)
(2) 10 A Power trim/tilt relay, Main relay, Warning buzzer, Indicator,
Starter solenoid switch, each meters
(3) 15 A PGM-FI ECU, Fuel injectors, CKP sensor 1, 2
(4) 10 A Data link connector, HO2 sensor heater, Indicator cable
(5) 15 A PGM-FI ECU, Ignition coils
(6) 30 A Gathered fuse (No.1, 3, 4, 5 Fuses)
Connected Components
SPARE ACG
FUSE (40 A)
ACG FUSE
(40 A)
FUSES
(10 A, 15 A, 30 A)