Danger Or Hazard Levels; Safety Instructions - Kärcher WPD 100 Advanced Originalbetriebsanleitung

Please read and comply with these origi-
nal instructions prior to the initial opera-
tion of your appliance and store them for
later use or subsequent owners.
Contents
Environmental protection
General notes
Transport
Proper use
Function
Connecting the appliance
Start up
Operation
Shutdown
Startup after shutdown
Storage
Care and maintenance
User menu
Consumables
Accessories
Troubleshooting
Technical specifications
Spare parts
Warranty
EC Declaration of Conformity
Maintenance sheet WPD 100 / 200 / 600 EN
Safety

Danger or hazard levels

DANGER
Pointer to immediate danger,
which leads to severe injuries or
death.
WARNING
Pointer to a possibly dangerous
situation, which can lead to se-
vere injuries or death.
CAUTION
Pointer to a possibly dangerous
situation, which can lead to mi-
nor injuries.
ATTENTION
Pointer to a possibly dangerous
situation, which can lead to
property damage.

Safety instructions

DANGER
Risk of electric shock!
 First remove the mains plug
before doing any job on the
device.
 The socket must be secured
through a residual current de-
vice (RCD) with a triggering
current of 30 mA.
DANGER
Mortal danger due to possibly
bursting CO gas tank.
2
 Install and fasten the pres-
sure gas container in an up-
right position.
18
 Never connect the pressure
gas container without pres-
sure reducer and safety
valve. The pressure reducer
EN 2
with safety valve must be ap-
EN 2
proved for the device type.
EN 2
 Do not expose the gas cylin-
EN 2
EN 2
der to direct sunlight.
EN 2
 The gas cylinder must be pro-
EN 3
EN 4
tected against excessive
EN 5
heating.
EN 5
EN 5
DANGER
EN 6
Risk of explosion!
EN 7
EN 11
 Do not use CO
EN 11
er. Riser bottles are, for ex-
EN 12
EN 14 ample, marked with a red
EN 14
warning label.
EN 14
DANGER
EN 14
15
Risk of suffocation on account of
escaping carbon dioxide.
 The installation room must be
aerated and ventilated suffi-
ciently or if a suitable gas
warning system must be in-
stalled.
 Country-specific statutory
provisions concerning the
minimum room size, warning
systems and ventilation dur-
ing the emptying of gas cylin-
ders must be observed.
WARNING
Health risk due to the contami-
nation with germs.
 When replacing the filter car-
tridges, ensure hygiene and
cleanliness.
 Wear sterile disposable gloves
when replacing the filter.
 Do not touch the water dis-
penser outlet with your fin-
gers or clean it with a clean-
ing cloth. If necessary, soak a
sterile cloth with RM735 (see
annex) and wipe it down with
this cloth.
 In order to be able to dis-
pense water of proper quality,
the surfaces of the appliance
must be cleaned regularly.
 The thermal hygienisation of
the device must be performed
at least every four weeks.
 A due hygienisation is indicat-
ed by a relevant message on
the display. The time of the
next hygienisation is pro-
grammed in the menu "Disin-
fection" (see Chapter "Care
bottle with ris-
2
1
-
EN
and maintenance/user menu/
operating parameters").
 After a warning regarding the
microbiological contamina-
tion has been issued by the
drinking water supplier, a hy-
gienisation must be per-
formed.
WARNING
Health hazards on account of
improperly repaired device.
 The appliance may only be
repaired by trained and
skilled personnel.
WARNING
Health risks due to hot water.
 When dispensing hot water,
proceed with particular cau-
tion.
WARNING
Health risk due to increased mi-
cro-organism concentration in
the water.
If the device has not been used
for more than 4 days, the follow-
ing actions must be taken:
 Set the appliance switch to
"I".
 Open the water supply.
 Start cleaning (see "Care and
Maintenance/Hygienisation").
WARNING
Risk of injury on account of
bursting bottles.
 Carbonated water must only
be filled into pressure-resist-
ant bottles (10 bar).
ATTENTION
If it cannot be ruled out that the
device has been stored or trans-
ported in a horizontal position,
you must wait 24 hours after the
set-up of the device before using
it. In case of non-observance,
the internal cooling device can
be damaged.