Mounting; Mounting The Sensor Head; Mounting The Evaluation Unit; Mounting The Display - SICK Visionary-B CV Betriebsanleitung

5.6

Mounting

5.6.1

Mounting the sensor head

5.6.2

Mounting the evaluation unit

5.6.3

Mounting the display

8022960/2018-07-16| SICK AG
Subject to change without notice
IMPORTANT!
This needs to be done twice for kit B and kit C.
1. Mount the two U-shaped brackets on the prepared support one after the other. Be
sure to mount the U-shaped bracket at the bottom first.
2. Carefully place the sensor head inside the U-shaped bracket at the top.
3. Secure the sensor head by inserting and tightening the screws at the side.
4. Adjust the installation angle of the sensor head and insert and tighten the two
screws at the rear to fix it in place.
5. Place the sensor head cover over the U-shaped bracket at the top and screw it
tight.
IMPORTANT!
This needs to be done twice for kit C.
1. Screw the mounting brackets to the evaluation unit.
2. Once the evaluation unit has been attached to the mounting brackets, position the
unit and the brackets in the prepared location inside the driver's cab.
IMPORTANT!
This needs to be done twice for kit C.
Carefully place the display inside the pre-mounted bracket.
b
3 D D R I V E R A S S I S T A N C E S Y S T E M | V I S I O N A R Y - B
MOUNTING
7 5