Specifications - Makita JR3060T Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Shoe
1-2. Shoe button
2-1. Shoe button
2-2. Shoe
3-1. Lever
3-2. Stopper

SPECIFICATIONS

Length of stroke
Max. cutting capacities
Strokes per minute (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for sawing wood, plastic, metal and
building materials with a strong impact. It is suitable for
straight and curved cutting.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model JR3060T
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Model JR3070CT
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Explanation of general view
4-1. Switch trigger
4-2. Lock button
5-1. Adjusting dial
6-1. Blade clamp sleeve
6-2. Released position
6-3. Fixed position
Model
Pipe
Wood
-1
)
Overall length
Net weight
Safety class
) : 87 dB (A)
pA
) : 98 dB (A)
WA
) : 89 dB (A)
pA
) : 100 dB (A)
WA
JR3060T
4.4 kg
ENE021-1
Vibration
The vibration
determined according to EN60745:
Model JR3060T
ENF002-2
Work mode : cutting boards
Vibration emission (a
Uncertainty (K) : 2.0 m/s
Work mode : cutting wooden beams
Vibration emission (a
ENG905-1
Uncertainty (K) : 1.5 m/s
Model JR3070CT
Work mode : cutting boards
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : cutting wooden beams
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
3
7-1. Blade
8-1. Blade clamp lever
10-1. Limit mark
11-1. Brush holder cap
11-2. Screwdriver
JR3070CT
32 mm
130 mm
255 mm
0 - 2,800
485 mm
4.6 kg
/II
total value (tri-axial
) : 15.5 m/s
h,B
2
) : 21.0 m/s
h,WB
2
2
) : 9.5 m/s
h,B
2
) : 10.5 m/s
h,WB
2
ENG900-1
vector sum)
2
2
2
ENG901-1