Cleaning The Spraying Arm; Complete Cleaning; Protection Against Frost Damage - hanseatic WQP12-7709H Gebrauchsanleitung

Cleaning the spraying arm

The nozzles in the spraying arm may calcify
or become dirty due to food scraps. Check
the nozzles regularly and clean them if re-
quired.
1. Empty both racks (13), (15) and remove
them.
2. Pull the lower wash arm (16) up and out.
3. The upper spraying arm is affixed using a
bayonet closure. To remove the spraying
arm, hold the bayonet fitting firmly and
release the wash arm by turning it clock-
wise.
Put on a work glove so that you can
hold the bayonet closure more firmly.
4. Clean the nozzles under running water.
5. Affix the spraying arm again after clean-
ing.
The spraying arm must be firmly affixed
and must be able to rotate freely.
Care and maintenance

Complete cleaning

In well-stocked supermarkets and drugstores,
you will find special dishwasher cleaning
products. The machine is cleaned with these
products when the dishwasher is empty. This
cleaning work is very intensive. You should
clean the dishwasher in this way from time to
time. When doing so, please note the manu-
facturer instructions on the packaging.
Protection against frost
damage
Position the dishwasher in an area which is
protected from frost, if possible. If this is not
possible, protect the dishwasher against frost
as follows:
1. Pull the mains plug out of the socket.
2. Close the tap and unscrew the inlet hose
(22).
3. Let the water out from the inlet hose flow
completely. Use a bowl with a flat edge or
a pan to collect the water.
4. Remove the (17) filters.
5. Use a sponge to remove water from the
bottom of the dishwasher.
Page EN-21