Herunterladen Inhalt Inhalt Diese Seite drucken

hanseatic WQP12-7709H Gebrauchsanleitung Seite 43

Teilintegrierbar
Vorschau ausblenden Andere Handbücher für WQP12-7709H:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

If there is a risk of frost, loosen the inlet
hose and allow the water to run off.
Only use regenerating salt which is suita-
ble for dishwashers.
Only add dishwasher salt immediately
before the next main dishwashing cycle,
as dishwasher salt which has overfl owed
can damage the seals and fi lters of the
appliance.
Immediately remove any spilt dishwash-
er salt with a damp towel, as otherwise
the stainless steel surfaces can be affect-
ed.
Ensure that the dishwasher detergent
and rinse aid are suitable for the appli-
ance.
Wipe away rinse aid which has over-
fl owed immediately as otherwise it can
lead to excessive foaming which can
compromise the results delivered by the
dishwasher.
Do not overload the appliance.
Position the upper dish rack at the high-
est setting if very large dishes are in the
lower dish rack to prevent obstruction of
the upper wash arm.
The seals of the door are sensitive to oil
and grease.
Do not apply grease to the door seals.
The door seals can be damaged by unsuit-
able cleaning agents.
Do not use harsh, aggressive, sol-
vent-based or abrasive cleaners.
Safety
The appliance is designed for a water
pressure of 0.4-10 bar (0.04-1.00 MPa,
2
40-100 N/cm
).
If the water pressure is higher than this,
install a pressure reducer. If in doubt, en-
quire about the water pressure with the
water supply company.
Never connect the appliance to the wa-
ter tap or the mixing arm of a water
heater (continuous fl ow heater, pres-
sure-free boiler etc.).
Ensure that the inlet hose is not kinked
and is carefully connected.
Do not cut through the inlet hose. It con-
tains electrical components! If the inlet
hose is damaged, have it repaired by a
specialist.
Do not immerse the inlet hose in water.
Do not use old or previously installed in-
let or outlet hoses.
Make sure that there is at least a 40 mm
drainage cross-section so that the water
can always be pumped out freely.
Make sure that the outlet hose is not
damaged or kinked.
Do not attach the outlet hose yourself;
have it installed by a specialist plumber.
Page EN-9

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis