Setting The Groove Depth - Holzmann PJ 100A Betriebsanleitung

NOTE:
 The center of the groove must be run from the workpiece outer edge at least 50 mm.
 With several wood joints 100 mm - 150 mm groove spacing hold.
Only for corner joint and center wall connection
 The vertical workpiece clamp to the workbench.
Only with mitred
 Clamp a workpiece with the mitered edge up on the workbench.
Only for frame connections and the longitudinal and transverse links
A workpiece clamp to the workbench.
 Set the groove depth according to the size of the timber connector to be used.
 See the table in the section "Setting the groove depth 12.1.3".
 Adjust the angle stop on the cutting tool and workpiece center.
 Align the center mark on the base plate on the pencil line on the workpiece.
 Turn on the power and move it forward immerse the cutting tool into the workpiece.
 After reaching the preset cutting depth the unit carefully drive back to the starting position.
Only for corner joint and center wall connection
 Clamp the horizontal workpiece at the workbench
The biscuit jointer machine is suitable for joints in solid wood, plywood, particle board, fiberboard,
Plexiglas and artificial marble, etc. 8 mm (5/16 in.) thickness.

12.1.3 Setting the groove depth

 Set the desired groove depth one with the wheel (9).
 The names on the dial reflect the different sizes of timber
connectors.
 You can adjust the depth of the groove with the screw
(10) fine.
 Slide the drive motor (3) forward to check the depth of
cut. The power supply must be disconnected for this pur-
pose.
Marking
Size of the timber connector
groove depth
HOLZMANN Maschinen Austria
0 10
0 10
8 mm 10 mm
www.holzmann-maschinen.at
20 M
20 ---
12,3 mm 20 mm
HOLZVERBINDUNGSFRÄSE / BISCUIT JOINTER
OPERATION
Seite 16
PJ 100A