Operation; Requirements For Safe Use; Switching The Appliance On And Off Gb; Setting The Temperature - hanseatic HKS 8555GA2S Gebrauchsanleitung

Seite GB-10

Operation

Operation

Requirements for safe use

– You have read chapter „Safety" from page
GB-5 and understand all the safety notices.
– The appliance is set up and plugged in as
described in chapter „Start-up" from page
GB-19.
Switching the appliance on
and off
NOTICE
Risk of damage!
Improper handling of the appliance
can lead to property damage.
The interior light must only be used
■
to illuminate the interior of the appli-
ance. It is not suitable for lighting a
room.
(1)
The temperature controller (1) can be used to
switch the appliance on and off. The temper-
ature controller is situated on the right-hand
wall of the fridge compartment.
Switching on
1. Set the temperature controller (1) to a set-
ting of between "1" and "7". The appliance
is then switched on. The compressor will
begin to work. The interior light will switch
on as soon as the door is opened and will
switch off if the door is closed.
2. If the appliance makes worrying noises
check the solid base and remove any ob-
jects that are on top of the appliance.
Switching off
1. Set the temperature controller (1) to "0".
The compressor is switched off. The ap-
pliance doesn't refrigerate.
2. To disconnect the appliance from the
power supply, pull the mains plug out of
the socket.
3. Empty the appliance and clean it (siehe
„Care and maintenance" on page GB-16).
4. Leave the door open slightly to avoid
mould formation.

Setting the temperature

WARNING
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature in the fridge and freezer compart-
ment.
Always adhere to the prescribed am-
■
bient temperature (see data sheet at
the end of this user manual).
Using the temperature controller (1), you can
set the temperature in the fridge and freezer
compartments.
• First select a medium setting.
• If, for example in summer, the ambient
temperature increases, so select a lower
setting accordingly.
In order to
– increase the refrigeration output in the
fridge and freezer compartments, turn the
temperature controller towards "7".
– decrease the refrigeration output in the
fridge and freezer compartments, turn the
temperature controller towards "1".