Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.1
Arm position
See figure 14. Always place the arm as close as possible to the source. When possible, place
the arm sideways to the source for best capture, to avoid interfering with the work process,
and to minimize the effect from cross draft. See figure 14(A).
Always check that the airflow is sufficient in the hood before work begins. Insufficient
airflow can be due to:
•
The fan impeller rotates in the wrong direction.
•
Hood, arm or ducts are blocked.
7
Maintenance
WARNING!
Risk of personal injury.
Always read section 3. Safety before installation, use, service, or troubleshooting of this
product.
7.1
Routine inspection and service
Follow the list in. Appendix B: Maintenance checklist to routinely inspect, and repair or
replace worn and damaged parts on the inside and outside of the product.
7.2
Spare parts
Contact your nearest authorized distributor or Nederman for advice on technical service or
if you require help with spare parts. See also www.nederman.com.
Ordering spare parts
When ordering spare parts always state the following:
•
Part number and control number (see the product identification plate).
•
Detail number and name of the spare part (see www.nederman.com).
•
Quantity of the parts required.
7.3
Recycling
The product has been designed for component materials to be recycled. Its different
material types must be handled according to relevant local regulations. Contact the
distributor or Nederman if uncertainties arise when scrapping the product at the end of its
service life.
FX
EX/ESD
EN
2
17
Werbung
Kapitel
Inhaltsverzeichnis
