LAVAZZA LB 1102 Bedienungsanleitung Seite 16

E N
MANUAL COFFEE DOSE BREWING
Place the cup as indicated (see
1
FOR COFFEE BREWING) and lift the capsule
loading arm.
An acoustic signal is heard and the red anomaly
warning light fl ashes.
Never put fi ngers or objects in the pod-hold-
er. Only Lavazza BLUE capsules may be intro-
duced in the pod holder.
Insert the Lavazza BLUE capsule in the appropri-
2
ate pod-holder.
Lower the capsule loading arm.
3
An acoustic signal and the turn-on of the red signal
light indicate the correct locking of the arm. If the
arm is lowered without the capsule being inserted,
by pressing one of the coff ee brewing buttons three
acoustic signals are emitted.
14
COFFEE BREWING
PREPARTIONS
4
4
Make sure the machine is ready for brewing: brew-
ing buttons are lit continuously.
Press the manual coff ee dose brewing button
to start brewing. Once the desired amount of
brewed coff ee is reached, press the button again
to stop brewing.
The pressed button flashes during coff ee brewing.
After the brewing, the same button remains lit and
flashing and then continuously lit, indicating the
machine is ready.
Do not fi ll the cup excessively in moving ve-
hicle and pay close attention when removing
the full cup.
PROGRAMMED COFFEE DOSE BREWING
The programming of the dose is done by using the
same button. Pressing any other button shall be ig-
nored. The programmed amount of brewed coff ee
(minimum 20 cc) can be changed by repeating the
programming. If a dose inferior to 20 cc is set, the
machine still memorizes 20 cc.
Perform steps 1, 2, 3 of paragraph
MANUAL COFFEE DOSE BREWING
Press and hold one of the two coff ee brewing
buttons for at least 3 seconds. The selected but-
ton and the green signal light flash; the machine
emits three sounds indicating the start of pro-
gramming. At this point, release the button.