Location And Function Of Parts And Controls; Front Panel - Sony DSC-1024G Bedienungsanleitung

Location and function of parts and controls

Front panel

1
S
ON/OFF
1 ON/OFF (power) switch and indicator
Press to turn the unit on and off.
The indicator on the switch lights when the unit is turned
on.
2 COMMAND MODE selector
When using the remote commander supplied with the
Sony monitor or TV, set it to TV.
When using the remote commander supplied with the
Sony projector, set it to PJ.
When not using the remote commander, set to OFF.
3 DISPLAY ON/OFF button and indicator
Press this button to turn on the indicator (DISPLAY ON) to
display the current operating mode on the screen.
Press it again to turn off the indicator to eliminate the
display (DISPLAY OFF).
Note
The main menu appears by pressing the MENU button,
even if the DISPLAY OFF mode is selected.
4 TEST PATTERN button and indicator
Press this button to turn on the indicator to display the test
pattern on the screen.
To turn off the test pattern, press the TEST PATTERN
button repeatedly until no test pattern is displayed, or
press the ON/OFF, INPUT SELECT or OUTPUT
FORMAT button.
5 LINE DOUBLER button and indicator
When the input signal format is NTSC or PAL, press this
button to turn on the indicator and activate the line doubler
function. Press it again to turn off the indicator and cancel
the line doubler function.
234 5 6
TV
IN NTSC PAL
PJ
OFF
DISPLAY TEST LINE OUTPUT OUT NTSC PAL
COMMAND
MODE ON/OFF PATTERN DOUBLER FORMAT GEN-LOCK
MENU
ENTER CENT
7
OVER FLOW
SIGNAL FORMAT
31.5k 37k 48k 64k OTHERS
31.5k 37k 48k 64k APERTURE
CHROMA PHASE CONTRAST
SIZE
6 OUTPUT FORMAT button
Press this button to select the desired output signal format.
The selected output signal indicator lights.
7 SIGNAL FORMAT indicators
IN NTSC PAL 31.5k
OUT NTSC PAL 31.5k
GEN-LOCK
IN indicators (upper)
Shows the input signal format that the unit automatically
detected.
31.5k, 37k, 48k and 64k indicate the horizontal scanning
frequencies. If the horizontal scanning frequency of the
input signal detected is one of these values ±1 kHz, the
corresponding indicator lights. If another value is
detected, the OTHERS indicator lights.
OUT indicators (lower)
Shows the output signal format selected by the OUTPUT
FORMAT button. The output signal format shown by each
indicator is as follows:
Indicator Format name
NTSC NTSC
PAL PAL
VGA 640 × 480
31.5k
VESA 800 × 600
37k
VESA 1024 × 768
48k
VESA 1280 × 1024
64k
For specifications of each format, see "Preset signals" on
page 47.
GEN-LOCK indicator
When the output signal format is PAL or NTSC and GEN
LOCK is set to ON on the menu screen, the GEN-LOCK
indicator lights or flashes.
c
OPEN SCAN CONVERTER DSC-1024G
INPUT SELECT
STILL
1 2 3
ZOOM
SIGNAL FORMAT
37k 48k 64k OTHERS
37k 48k 64k
29