Sony DSC-1024G Bedienungsanleitung Seite 26

WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
Dangerously high voltages are present
inside the unit. Do not open the cabinet.
Refer servicing to qualified personnel
only.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician
for help.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
Warning on Power Connection
• Use a proper power cord for your local power supply.
Plug type
115 Volts
Cord type
Minimum cord set
rating
230 Volts Cord length
(not provided on
Safety approval
standard cord set)
Autoranging usiversal power supply works anywhere; the unit self-adjusts if the appropriate power cord and plug for
the local voltage are used.
CEE-22 cord set,
female end (all
power cord sets)
26
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la class B respecte toutes les
exigences du Règlement sur le matériel brouilleur du
Canada.
NOTICE
This notice is applicable for USA/Canada only.
If shipped to USA/Canada, install only a UL LISTED/CSA
LABELLED power supply cord meeting the following
specifications.
SPECIFICATIONS
Plug Type
Cord
Length
Rating
Cette notice s'applique aux Etats-Unis et au Canada
uniquement.
Si cet appareil est exporté aux Etats-Unis ou au Canada,
utiliser le cordon d'alimentation portant la mention UL
LISTED/CSA LABELLED et remplissant les conditions
suivantes:
SPECIFICATIONS
Type de fiche
Cordon Type
Longueur
Tension
United States,
Continental Europe
Canada, Japan
NEMA S-15P
CEE 7/VII (Schuko)
SJT
HAR (HO5VV-F3G1.0)
7 A/125 V
7 A/250 V
3 x 18AWG
2 m ± 0.1m
2.5 m ± 0.1 m
UL/CSA
HAR
The socket-outlet should be installed near the equipment
and be easily accessible.
Nema-Plug 5-15p
Type SVT or SJT, minimum 3 x 18 AWG
Maximum 15 feet
Minimum 7A, 125V
Fiche Nema 5-15 broches
SVT ou SJT, minimum 3 x 18 AWG
Maximum 15 pieds
Minimum 7A, 125V
United Kingdom, Australia, New
Ireland Zealand
BS 1363
SAA AS 3112
HAR (HO5VV-F3G1.0)
CDB03PLP
7 A/250 V 7 A/250 V
2.5 m ± 0.1 m 2.5 m ± 0.1 m
BSI, ASTA Dept. of Energy of New
South Wales