Installation; Surface Mount - Eneo VKCD-13120F2810 Montage- Und Betriebsanleitung

5. Installation

5.1 Surface Mount

Ceiling or wall
L-Wrench
Mount base
Mount screws (7) and
blind cover () for
mount base
Dome base
Wrench bolts (5) for
fitting to mount base
Bubble
Quick installation guide
. Locate the mounting template at the installation
position and drill the ceiling or wall if needed.
. Place mount base on pre-drilled position and fix it
through mount base mount holes (n) (4x) by using
mount screws (7).
Assemble the cable pipe, otherwise tighten blind cover
().
3. Open bubble by loosening ring cover fixing screws (j)
(3x).
CAUTION
Extreme care should be taken NOT to scratch the
dome surfaces and to protect it from dirt or dust at
any time.
4. Mount holes (f) (x3) for dome base and hole (m) should
be aligned before fixing dome base to mount base by
using wrench bolts (5).
And tighten wrench bolts (5).
5. Route the power/video cable to the connecting place.
CAUTION
Care should be taken the cable is NOT to be
damaged, kinked or exposed in the hazardous area.
6. Set the camera's angle (Pan, Tilt, inclination)
7. Adjust Zoom & Focus (a) by using focus adjust driver
(4).
8. Put bubble over dome base and tighten ring cover fixing
screws (j) (3x) by using L-shape star wrench (3)
CAUTION
Tighten enough ring cover fixing screws (j) (3x)
so that there should be NO gap between lens hood
(b) and clear bubble (i) (to avoid the light inflow
from IR LEDs).
4