Configuration Via Display And Operating Unit; Configuring The Measuring Task; Configuring Pressure Measurement - WIKA UPT-20 Betriebsanleitung

8. Configuration via display and operating unit

8. Configuration via display and operating unit

8.1 Configuring the measuring task

8.1.1 Configuring pressure measurement

EN
1. Open the operating menu with [↵].
Select "Basic setting" and confirm with [↵].
2. Select "Application" and confirm with [↵].
3. Select "Pressure" and confirm with [↵].
4. Select "Unit" and confirm with [↵].
5. Select pressure unit and confirm with [↵].
» Pressure unit is set.
6. Go back one menu level using [ESC].
Select "Mode" and confirm with [↵].
7. Select "Pressure" and confirm with [↵].
» Mode is set.
8. Scale the measuring range.
→ See chapter 8.3 "Scaling the measuring range".
9. Perform a mounting correction.
→ See chapter 8.5 "Mounting correction (offset)".
» Pressure measurement is configured.
24
Приборы & Автоматика +7 (495) 712-3209, 712-3218, 988-0959 www.k-avtomatika.ru 9880959@mail.ru
WIKA operating instructions process transmitter, model UPT-2x