Resetting The Detailed Settings (Lh71A Lathe Function And Lh72) - Magnescale LH71A-2 Bedienungsanleitung

5-3-3. Resetting the Detailed Settings
Power ON
Current value display
Detailed
settings
Display
resolution
Scaling
Compensation
value
Flicker control
Sleep
or
Start of operation
∗ When the segmented error compensation value is set,
the unit switches to reference point acquisition mode.
LH71A / LH72
(LH71A lathe function and LH72)
q
Select axis
Use and
Performed for each axis.
(Note)
Use at
w
Enter the setting value
e
Use to select the setting (compensation), and then set each option
Select axis
Enter the compensation value
Enter the
position
r
Use to select setting content
t
Use to select setting content
(When the display resolution is 0.001 mm)
to select setting content
Enter the
compensation value
is displayed,
5. Settings
q Setting at
measuring unit
resolution or
higher/Diameter
display at
measuring unit
resolution
(except for
angle)/Polarity
∗ The X-axis
polarity should
be set so that
the value of the
cutting direction
decreases when
using diameter
display.
w 0.100000 -
9.999999
e OFF/LIN Err/
SEG Err
∗ See Part 5-5,
or
"Compensation".
r OFF/1/2
t OFF/1/5/10/30/
60
5-9
(E)