How To Open The Housing; Fastening The Lens And The Camera To The Internal Slide - Videotec ULISSE MAXI NETCAM Bedienungsanleitung

7.2.1 How to open the housing

Loosen the leak-proof screws placed on the sides and
lift the upper part of the housing.
Fig. 7
After installation and wiring, close the
product again.
7.2.2 Fastening the lens and the camera
to the internal slide
It is necessary to insulate the camera
body from the attachment slide in order
to prevent interference with the Ethernet
signal.
Maximum overall weight allowed for
camera and lens must not exceed 7.6kg
(16.8lb).
Connect the camera (02) to the lens (01).
Fasten the L-shaped small aluminium bracket (03) to
the camera by means of the nylon washer (04) and
the 1/4" screw (05).
Fig. 8
Position the lens on the slide (02) interposing the
plastic spacer (01). Fasten the whole assembly by
means of the nylon washer (03)and the 1/4" screw
(04).
MNVCUPTMAXIR_1625_EN
01 02
03
04
If necessary, use the additional spacers to correctly
position the camera and lens.
02
03
04
Fig. 9
Fasten the aluminium plate (01) on the slide by
means of the screws and relative washers (02).
Fig. 10
Fix the L-bracket with the screw.
Fig. 11
05
01
01
02
15