Important Note Regarding Product Liability - WAGNER WallPerfect W 565 I-Spray Originalbetriebsanleitung

W 565
Problem
Too much fog of
coating material
(Overspray)
Paint in the
ventilating hose
Poor covering
capacity on the wall

Important Note regarding Product Liability!

Due to an EC ordinance in effect since 01.01.1990, the manufacturer is liable for his product
only if all parts originate from or were approved by the manufacturer and the devices
are assembled and operated correctly. The use of other accessories and spare parts can
partially or completely invalidate the liability.
How the product is handled, including preparation of the work place and spray
paint as well as the final result, is the sole responsibility of the operator.
Wagner excludes any liability for damage which may arise from overspray, application
errors, touch-ups, or non-compliance with the instructions provided here.
Cause
•
Distance to the object too large
•
Too much coating material
applied
•
Diaphragm soiled
•
Diaphragm defective
•
Spray material is too cold
•
Highly absorbent surface or paint
with poor covering capacity
•
Distance too large
Remedy
Reduce distance
➞
Turn material volume
➞
adjusting screw to the
left (-)
Clean the diaphragm
➞
Replace the diaphragm
➞
Heat spray material
➞
maximum 40°C)
Cross spray (Fig. 8)
➞
Closer to the object
➞
GB
(to
25