Primo Star / Primo Star iLED
1.2
Instrument safety and EMC
The Primo Star and Primo Star iLED microscopes have been designed, produced and tested in compliance
with the standards DIN EN 61010-1 (IEC 61010-1) and IEC 61010-2-101 "Safety requirements for
electrical equipment for measurement, control and laboratory use ".
The Primo Star and Primo Star iLED microscopes meet the requirements of the EC Directive 98/79/EC
Annex 1 and carry the
Radio interference suppression in compliance with EN 55011 Class B
Noise immunity in compliance with DIN EN 61326
The instruments have to be disposed of in compliance with the WEEE Directive 2002/96/EC.
1.3
Unpacking, transportation, storage
Please observe the following safety notes for unpacking, transportation and storage of the microscope:
The microscope is supplied packed to commercial standards in a plastic case with cardboard
−
packaging; use the original packaging only for any transportation.
−
Retain the original packaging for longer storage or return to the manufacturer.
−
When unpacking the equipment, verify that all parts specified on the delivery note are present.
−
Keep transportation and storage temperatures as specified in Technical Data.
−
Set up the microscope on a stable worktable with solid and smooth tabletop.
−
Do not touch optical surfaces to avoid fingerprints.
Risk of burns due to hot surface on the underside of the microscope during operation and up
to 10 minutes after power off.
1.4
Disposal
Please observe the following safety notes for the disposal of the microscope:
Defective microscopes should not be disposed of with household waste; dispose of them in
compliance with the provisions of the law.
The manufacturer of the device is under the legal obligation to take back defective devices.
Batteries of the battery supply unit should not be disposed of with household waste; dispose
of them in compliance with the provisions of the law.
M60-2-0011 v 08/2008
Notes on Instrument Safety
mark.
Carl Zeiss
5