Basic Operations; Startup And Self-Test - HACH LANGE FH950 Basis Bedienungsanleitung

Attach the velcro strap
Use the velcro strap to hold the extra cable. Refer to
Figure 5 Attach the velcro strap
1 Loop side

Basic operations

Startup and self-test

Chemical or biological hazards. If this instrument is used to monitor a treatment process and/or
chemical feed system for which there are regulatory limits and monitoring requirements related to
public health, public safety, food or beverage manufacture or processing, it is the responsibility of the
user of this instrument to know and abide by any applicable regulation and to have sufficient and
appropriate mechanisms in place for compliance with applicable regulations in the event of malfunction
of the instrument.
Fire and explosion hazards. Do not use or store the instrument in direct sunlight, near a heat source or
in high temperature environments such as a closed vehicle in direct sunlight. Failure to take this
precaution can make the battery overheat and cause a fire or explosion.
The battery must be installed in the meter and charged before use. For more information about
battery installation and replacement, refer to
information on how to charge the battery, refer to
Note: The meter is not operational while the battery charges.
1. Push the meter power button until an audible beep is heard.
The meter does a self test and the display shows the results. If the meter fails the self-test, the
display shows FAIL next to the failed parameter. If the sensor fails, attach a different sensor if
available.
2. When the self test is complete, push OK to go to the Main Menu.
3. To de-energize the meter, push the power button again. In the Confirmation screen, select Yes
and push OK.
If the portable meter becomes unresponsive, push and hold the power button for more than
3 seconds to force the power off. Do not force off the power in normal operation or when the file
access icon is visible.
Instrument self test
The meter does a diagnostic self-test when energized. After the self-test is complete, the display
shows the self-test results. Push OK to go to the Main Menu.
If the meter fails the self-test, the display shows FAIL next to the parameter in question. If the sensor
fails, attach a different sensor if available.
Figure 5.
2 Hook side
D A N G E R
W A R N I N G
Install or replace the battery
Charge the battery
on page 18. For
on page 18.
English 11