Specifications; Standard Accessories; Battery Removal/Installation - Hitachi DV 12DV Bedienungsanleitung

10. Using an exhausted battery will damage the
charger.
11. Do not insert foreign object into the air ventilation
slots of the charger.
Inserting metal objects or inflammables into the
charger air ventilation slots will result in electrical
shock hazard or damaged charger.

SPECIFICATIONS

POWER TOOL
Model
No-load speed (Low/High)
No-load impact rate (Low/High)
Brick
Drilling Wood
Capacity
Metal
Machine screw
Driving
Wood screw
Rechargeable battery (FEB12S)
Weight
CHARGER
Model
Charging time
Charging voltage
Weight

STANDARD ACCESSORIES

1 Plus driver bit (No. 2 × 55L) ......... 1
2 Charger (UC12SD) .............................. 1
DV12DV
3 Plastic case .......................................... 1
4 Hook ..................................................... 1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES ...... (sold separately)
1. Battery (FEB12S)
2. Drill bit for brick
Diameter, 6.5 mm, 8 mm, 9.5 mm, 10 mm
Optional accessories are subject to change without
notice.
APPLICATIONS
Drilling of brick and concrete block, etc.
12. Wear ear protections
Exposure to noise can cause hearing loss.
13. When mounting a bit into the keyless chuck, tighten
the sleeve securely. If the sleeve is not tight, the
bit may slip or come off, causing injury.
0 – 350/0 – 1250 min
0 – 5250/0 – 18750 min
Steel: 10 mm, Aluminum: 10 mm
5.1 mm (diameter) × 32 mm (length) (Requires a pilot hole)
UC12SD
Approx. 1 hour (at 20°C)
12 V
1.4 kg
Driving and removing of machine screws, wood
screws, tapping screws, etc.
Drilling of various metals.
Drilling of various woods.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the impact drill, charge the battery as
follows.
1. Insert the battery in the charger.
Position the battery so that the nameplate faces
toward the nameplate of the charger and press in
the battery until it comes into contact with the
bottom surface. (See Figs. 1 and 3.)
2. Connect the charger power cord to the receptacle.
Connecting the power cord will turn on the charger
(the pilot lamp lights up).
CAUTION
If the pilot lamp does not light up, pull out the
power cord from the receptacle and check the
battery mounting condition.
DV12DV
–1
(/min)
–1 (/min)
10 mm
18 mm
6 mm
Ni-Cd battery, 12 V
1.9 kg
English
6