Others; Troubleshooting/Repair - Nikon Coolshot Bedienungsanleitung

Others

Jp
En This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
Es
(2) This device must accept any interference received, including interference that may cause undesired operation.
Fr
De
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
It
15 of the FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection against
Se
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
Nl
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
Ru
equipment does cause harmful interference to radio or television reception, which can be determined by turning
Pt
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
Pl
measures:
• Reorient or relocate the receiving antenna.
Fi
• Increase the separation between the equipment and receiver.
No
• Consult the dealer or an experienced radio/TV technician for help.
Dk
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cz
Ro
This Nikon Laser Rangefinder is a basic rangefinder. Its results cannot be used as official evidence.
Hu
32

Troubleshooting/Repair

If your Nikon Laser Rangefinder should require repair, please contact your local dealer for details regarding where to
send it. Before doing so, you are advised to consult the Troubleshooting Table below.
Symptom
• Depress POWER button.
Unit does not turn on — LCD fails to
• Check battery insertion
illuminate
• Replace the battery if necessary.
• Be sure that nothing, such as your hand or finger, is blocking the laser
emission aperture and laser detector.
• Be sure that the laser emission aperture and laser detector are clean.
Target range cannot be obtained Clean them if necessary.
• Be sure that the target shape and condition are appropriate to reflect the
laser beam.
• Replace battery.
• Be sure to hold the unit steady while measuring.
[- - -] ("Cannot measure") appears
• Be sure the target is within measuring range (10-550m/11-600 yards)
• Be sure that nothing, such as leaves or grass, is between the Nikon Laser
Closer target cannot be measured
Rangefinder and the target.
Target beyond a certain distance • Be sure that nothing, such as leaves or grass, is between the Nikon Laser
cannot be measured Rangefinder and the target.
Jp
En
Es
Fr
Check Points
De
It
Se
Nl
Ru
Pt
Pl
Fi
No
Dk
Cz
Ro
Hu
33