Technical Specifications; Safety Instructions; Symbols And Icons - Parkside SHARPENING Originalbetriebsanleitung

GB

Technical specifications

Nominal input voltage
............................. 220 - 240 V~, 50 Hz
Power consumption .. 65 W, (S2 10 min)*
Measurement idling speed
Safety class .....................................
Protection category......................... IP 20
Weight ......................... approx. 1.35 kg
Grinding angle range ................15° - 50°
Sharpness drill diameter ............ 3 -10 mm
Sharpness knife width .............. 6 - 51 mm
Grinding disc ........................................
Outer diameter .................. Ø 49.5 mm
Borehole diameter ............ Ø 10.14 mm
Thickness ................................ 7.9 mm
Abrasive ............................... Diamond
Base body .................................. Metal
Working speed ................ max. 60 m/s
Rotational speed ....... max. 23100 min
Sound pressure level
(L ) ................... 59,3 dB(A); K
PA
Sound power level
(L ) ................. 73,5 dB(A); K
WA
* A break is introduced after 10 minutes of
uninterrupted operating duration until the
device temperature differs 2 K (2°C) less than
room temperature.
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
Technical and optical changes may be
undertaken in the course of further develop-
ment without notice. All dimensions, refer-
ences and information in this instruction
manual are therefore not guaranteed. Legal
claims made on the basis of the instruction
manual can therefore not be considered as
valid.
6
n ... 6700 min
-1
0
II
-1
= 3 dB
PA
= 3 dB
WA

Safety Instructions

Symbols and icons

Symbols on the device:
Warning!
Read the instruction manual.
Wear ear protection.
Risk of electric shock! Disconnect
from the mains before carrying out
maintenance and repair work.
Safety class II
Do not dispose of electrical equip-
ment in household waste.
Symbols in the manual:
Warning symbols with in-
formation on damage and
injury prevention.
Instruction symbols (the instruction is
explained at the place of the excla-
mation mark) with information on
preventing damage.
Help symbols with information on
improving tool handling.