Fitting The Tandem Seat Units; Removing The Tandem Seat Units; Fitting The Tandem Carrycots; Removing The Tandem Carrycots - KIDDY evostar1 Bedienungsanleitung

6.3. Fitting the tandem seat units.

Fit the tandem adaptors as described in point 6.1. Fit the lower seat unit adaptor
cups (fig. 36) on to the seat legs (left and right). With the chassis handle fully
extended, lower the seat unit into the tandem adaptors until it locks into place
with a click (fig. 37).
Note: The adaptor cups are only for use with the tandem seat in the lower po-
sition.
Note: Always fit the lower seat first in the forward facing position. The lower seat
unit has a 2 position recline only. Do not try force the seat into the 3rd recline
position. Always fit the upper seat unit in the forward facing position.

6.4. Removing the tandem seat units.

Depress the grey buttons on the side of the seat unit (fig. 38; no. 1) and lift the
seat upwards from the chassis (fig. 38; no. 2). Remove the adaptor cups.

6.5. Fitting the tandem carrycots.

Fit the tandem adaptors as described in point 6.1. Holding the lower carrycot by
the carry handle; guide the carrycot in horizontally foot-end first until the fittings
on the carrycot line up with the fittings on the tandem adaptor. Push the carrycot
into the tandem adaptor until it locks into place with a click. Fit the upper car-
rycot into the upper position by lowering it into the tandem adaptor until it too
locks into position with a click (fig. 39).
Note: Always fit the lower carrycot first, in the forward facing position. Always fit
the upper carrycot in the parent facing position.
The carrycot hood has an intermediate position (45 degrees) to allow viewing
when the carrycot is used in the tandem mode, lower position.

6.6. Removing the tandem carrycots.

Depress the buttons on the side of the carrycots (fig. 40; no.1) and lift upwards
from the chassis (fig. 40; no. 2).
EN
24 24