Jet JWBS-24 Gebrauchsanleitung Seite 7

Table insert:
Replace a worn table insert.
The table insert (Fig 18) must be
made out of cutable material (e.g.
wood, plastic, aluminium)
Fig 18
Jet part number: 6295177AE.
The table insert may not project above
table surface.
Air blower:
Monthly apply a few drops of oil to the
air pump on the motor.
Saw blades:
The servicing of sawblades should
only be performed by a trained
person.
Only use sharp and properly set
sawblades.
9. Trouble shooting
Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
*Overload has reacted-
Wait and start again.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*dust on wheel-
clean tires.
*sawblade has cracks-
replace sawblade immediately
Cut is not square
*Table stop setting wrong.
*Blade guide setting is bad
Cutting surfaces is bad
*Wrong sawblade used
*resin collection on sawblade
*sawblade is dull
*Blade guide setting is bad
*Blade tension too low
*workpiece inhomogeneous
*Feed pressure too high-
Do not force the workpiece.
10. Environmental protection
Protect the environment.
Your appliance contains valuable
materials which can be recovered or
recycled. Please leave it at a
specialized institution.
11. Available accessories
Refer to the JET-Pricelist
for various saw blades.
Stock number 709207
Foldable roller stand.
12. Safe operation
See appendix A (on the last pages of
this operating manual)
A.1: Performing high cuts
A.2.: Performing diagonal cuts
A.3.: Tenon cutting
A.4.: Cutting of wedges
A.5.: Curved cuts
A.6.: Arc cuts
A.7.: Cutting with template
A.8.: Circular cutting
A8.1 Set up without workpiece
A8.2 Placing the workpiece
A8.3 Machining
9