Troubleshooting - BOMANN KG 7300 Bedienungsanleitung

NOTE: NOTE:
NOTE: NOTE:
If necessary, use the included ice
scraper.
The fridge fridge has an automatic defrosting
fridge fridge
system. During defrosting water drops
drains off at the back of the cooling
chamber. The thaw water running
through a channel, is collected in a drip
tray located on the compressor, where it
will evaporate. Make sure the water dis-
charge opening does not get clogged. A
light formation of ice on the interior back
during operation is normal.
To achieve better cooling and to save
energy, defrost the freezer
follows:
To start the defrosting process turn
•
the temperature control to the off
state and disconnect the plug or turn
off the fuse.
Remove the food items and keep
•
covered at a cool location.
When the ice has melted, wipe the
•
condensate away and dry the appli-
ance interior.
Then you may restart the appliance
•
by connecting the plug and turning
the temperature control.
freezer regularly as freezer freezer
Changing the bulb Changing the bulb
Changing the bulb Changing the bulb
Lamp data: 220 Lamp data: 2 20- - - - 240 V
Lamp data: 2 Lamp data: 2 20 20
Remove the lamp cover carefully.
•
Replace the defective illuminant.
•
Replace the lamp cover.
•

Troubleshooting

Troubleshooting
Troubleshooting Troubleshooting
Befo Before you contact a Befo Befo re you contact a re you contact a specia re you contact a
Problem Problem Problem Problem
Unit is not
working
properly or
at all
Loading is
too warm
Loud noise
during oper-
ation
Water on the
unit bottom
Light does
not work
NOTE: NOTE: NOTE: NOTE:
If a problem still persists after following
the steps above, contact your trader or an
authorized technician.
32
240 V~ ~ ~ ~ , max. 10 W , max. 10 W
240 V 240 V , max. 10 W , max. 10 W
specia specia special l l l ist ist ist ist
Cause / Action Cause / Action Cause / Action Cause / Action
∙ Check the power supply /
temperature setting / ambi-
ent temperature. ∙ Unblock
the ventilation openings,
install the appliance freely.
∙ Check the temperature
setting / ambient tempera-
ture. ∙ Open the door only
as long as necessary.
∙ Check the appliance
position. ∙ See the section
"Operating noise".
∙ Check the temperature
setting / water discharge
channel or opening.
∙ Check the power supply.
∙ See "Changing the bulb".