Using The Monitor; Installing / Changing The Batteries; Connecting The Ac Adapter - AND UA-767 NFC Bedienungsanleitung

Installing / Changing the Batteries

1. Slide the battery cover up to open it.
2. Remove the used batteries and insert
new batteries
compartment as shown, taking care
that the polarities (+ and -) are correct.
Use only R6P, LR6 or AA batteries.
3. Slide the battery cover down to close.

Connecting the AC Adapter

Insert the AC adapter plug into
the DC jack.
Next, connect the AC adapter to
an electrical outlet.
Use the specified AC adapter.
(Refer to page 22.)
Note: When inserting the batteries or connecting the AC adapter, "Year" blinks
automatically and the screen will go to the clock setting mode. Set the clock
as described on page 8.
Every time the batteries are inserted or the AC adapter is connected, the
clock needs to be reset. Measurement cannot start until a time is set on the
clock.
CAUTION
Insert the batteries as shown in the battery compartment. If installed incorrectly,
the device will not work.
When (LOW BATTERY mark) blinks on the display, replace all batteries with
new ones. Do not mix old and new batteries. It may shorten the battery life, or
cause the device to malfunction.
Wait two seconds or more after turning the device off, to replace the batteries.
If (LOW BATTERY mark) appears even after the batteries are replaced, make a
blood pressure measurement. The device may then recognize the new batteries.
(LOW BATTERY mark) does not appear when the batteries are drained.
The battery life varies with the ambient temperature and may be shorter at low
temperatures.
Use the specified batteries only.
Remove the batteries if the device is not to be used for a long time.
The batteries may leak and cause a malfunction.

Using the Monitor

into the battery
English 7
Step 1
Step 3
Step 2
DC jack
AC adapter plug