Troubleshooting - AND UA-767 NFC Bedienungsanleitung

Problem
Nothing appears
on the display,
even when the
power is turned
on.
The cuff does not
inflate.
The device does
not measure.
Readings are too
high or too low.
Other
Note: If the actions described above do not solve the problem, contact the dealer.
Do not attempt to open or repair this product, as any attempt to do so will
make your warranty invalid.

Troubleshooting

Possible Reason
Batteries are drained.
Battery terminals are not in
the correct position.
Battery voltage is too low.
(LOW BATTERY mark)
blinks. If the batteries are
drained completely, the mark
does not appear.
The cuff is not applied
properly.
You moved your arm or body
during measurement.
The cuff position is not
correct.
The value is different from
that measured at a clinic or
doctor's office.
Replace all batteries with new ones.
Reinstall the batteries with negative
and positive terminals matching
those indicated on the battery
compartment.
Replace all batteries with new ones.
Apply the cuff correctly.
Make sure you remain very still and
quiet during measurement.
Sit comfortably and still.
Place your arm on a table with your
palm facing upward and the cuff at
the same level as your heart.
If you have a very weak or irregular
heat beat, the device may have
difficulty in determining your blood
pressure.
Refer to "Why Measure Blood
Pressure at Home?".
Remove the batteries. Place them
back properly and take another
measurement.
English 20
Recommended Action