Wd Buggy Chassis - Reely BIG PYRO Bedienungsanleitung

3 d
escRIPTIOn Of The mOdel
3.2
2 wd B c
uGGy hassIs
2/4 WD
2/4 Wheel Drive driven by  or 4 wheels.
Air filter
The air filter consists of a plastic housing with a foam insert. The intake air is sucked via the foam into the suction hole of
the carburettor. The filter prevents the penetration of dust and dirt into the carburettor and thus into the engine.
Alignment
a b
Position of the wheel level to the driving direction:
a) Toe-in – Wheels point inwards
b) Toe-out – Wheels point outward
Axle leg
This is where the axle turns. The steering levers are located on the front axle legs.
Bumper
The bumper (impact protection) made of impact resistant plastic material, is raised and rests additionally on the front trans-
verse control arm support.
nachspur.eps
vorspur.eps
Damper plate
The damper plate at the front is part of the support of the upper and lower transverse control arms. The shock absorbers are
fastened at the upper end on an axle respectively between the front and rear transverse control arm support between two
adjusting rings.
The shock absorbers of an axle are thus connected to each other at the upper end via this construction.
Differential
Differential gear. Equalizes the different revolution speeds, e.g. between the wheel on the inside of a bend and the outside of
a bend.
36
Operating instructions WD GP Buggy Chassis „Big Pyro" RTR No. 3 35 0