e) Installing the Wings
Insert the wing brace receptacle (1) into the side of the fuselage (2). Rotate the
receptacle by 90° to lock it in.
Plug the aileron connection cable (1) into the aileron output sockets (2).
Our tip: To prevent the plug connection from getting loose, use heat-shrink
tube or adhesive tape.
Then place the wing on the fuselage. Observe hat the two markings (1) must
point exactly to the middle of the fuselage.
Fasten the wing with the two enclosed rubber rings (2).
40
Figure 10a
Figure 10b
Figure 10c